which cisco ios switch command is used to configure the use of lacp on an interface?

In the case of 0x11, bits 0 and 4 are set, so hashes 1 and 4 are assigned to this link.ĭepending on the switch, the load may show as 00 on all links. When these are converted into an 8-bit binary value (for example 0x11 is 0001 0001), the ‘on’ bits refer to the hashes that are allocated to the link. Depending on the switch, this may include Hex values such as 11, 22, 44, and 88. On some switches, the show interfaces port-channel ID etherchannel command has to be used. Time since last port Un-bundled: 380d:06h:04m:37s Gi0/4 Time since last port bundled: 380d:06h:04m:27s Gi0/2 Logical slot/port = 2/40 Number of ports = 4 show etherchannel port-channelĪge of the Port-channel = 380d:06h:04m:51s

More detail can be found with show etherchannel port-channel or show etherchannel detail. The load-balancing type can be found with show etherchannel load-balance show etherchannel load-balanceĮtherChannel Load-Balancing Configuration:ĮtherChannel Load-Balancing Addresses Used Per-Protocol: Firstly, show etherchannel summary can be used to get basic information, such as a list of port channels, the physical links they contain, link up/down status, and protocol type.

There are several commands to begin troubleshooting the etherchannel. This includes knowing whether communication is within a single subnet, or whether routers are involved. If possible, try to understand the pattern of traffic passing over the etherchannel. For example, know the etherchannels in use, the number of links in the channel, and so on. When troubleshooting, the best place to start is to understand the topology you’re working on.

Which cisco ios switch command is used to configure the use of lacp on an interface?